Smart (2010-17)

WARNING:

Accidental air bag deployment is possible. Personal injury may result. Avoid area near steering wheel and instrument panel even if air bags have deployed. Dual-stage air bag modules may be present that could contain an undeployed stage. When disposing of a deployed dual-stage air bag, always treat it as a live module. See appropriate Air Bag Service & Repair article in Mitchell’s Repair Center TechAdvisor product for more information. ©Mitchell International

Application Year Type Table
Fortwo 2010-17 DP2, HI, KI Smart-1
SI

D/P—Driver’s & Passenger’s Side D/P2—Driver’s & Passenger’s Side (Dual-Stage) DS—Driver’s Side HI—Head Impact KI—Knee Impact SI—Side Impact PS2—Passenger’s Side (Dual-Stage) WP—Whiplash Protection

Smart-1 See Smart (2010-17) application table
Replace after Deployment Inspect & if Damaged, Replace Component (Even if Air Bag Did Not Deploy) Comments
  • Deployed driver’s side air bag module

  • Deployed passenger’s side air bag module

  • Instrument panel (if passenger air bag deployed)

  • Deployed side air bag module

  • Deployed seat belt pretensioner(s)

  • SRS control unit 1

  • Any defective or damaged components

  • Air bag modules

  • Steering wheel

  • Instrument panel & mounting points

  • All impact sensors

  • Seat belts and mounting points

  • SRS wiring harness & connectors

  • Manufacturer may consider some fasteners and attachments non-reusable. Refer to manufacturer’s service repair manual or appropriate Air Bag Service & Repair article in Mitchell’s Repair Center TechAdvisor product for more information.

  • Proper operation of air bag system requires that any repair made to the vehicle structures return it to its original production configuration.

  • After vehicle is repaired, ensure AIR BAG warning light is functioning properly.

1SRS control unit be replaced if housing has been deformed or damaged in any way, if console has been deformed, even if the control unit is visually intact, in event of an electrical fault or where air bag has been triggered three times. Following installation, new SRS control unit must be programmed and parameterized.