Front Assembly R&R

 

Included Operations

•    Remove and replace radiator support and both apron/rails
•    Remove and install:

Cowl trim if necessary

•    Remove and install or replace:

Shroud and radiator assembly

Impact absorbers or mounting arms if necessary to perform operation

•    Loosen and pull back carpet and insulation as required and if necessary
•    Remove and replace caulking for standard factory application

                                      IMPORTANT REMINDER: Labor times for inner panels, rails or reinforcements are with outer panels removed.

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish front assembly
•    Aim lamps
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install:

Bumper assembly

Hood panel

Front panel

Front fenders

Engine

Wiring and/or wiring harness

Hard shell cowl panel insulation

•    Remove and replace:

Radiator hoses

Fan, pulley, fan clutch or belts

Decals (example: EPA, body identification, caution/danger)

•    Remove and install or replace:

Suspension assemblies

Bolted parts and assemblies (example: fluid reservoirs and coolers, vapor canister, cruise control, air conditioning components)

Instrument panel and center console

Seat assemblies

Windshield and mouldings

Air safety bag

Upper reinforcements

•    Wheel alignment
•    Frame set up (see Definitions page P1, estimate time required)
•    Trimming of welded assembly to be installed