Rocker Panel R&R

 

Included Operations

•    Remove and replace inner and outer panels
•    Cut at door posts, center pillar, lock pillar or dog leg
•    Remove and install or replace:

Cowl side trim

Center pillar trim

Quarter trim at sill

Sill plates

Seats

•    Loosen and pull back carpet and insulation as required
•    Remove and replace caulking for standard factory application

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not e recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish rocker panel
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install or replace:

Front and rear doors

Rocker moulding

Control cables (latch release, etc.)

Fluid lines

Restraint systems

•    Remove and replace or loosen rear edge of front fender
•    Trimming of welded assembly to be installed