Rocker Panel & Center Pillar R&R

 

Included Operations

•    Remove and replace inner and outer rocker panel and center pillar
•    Cut center pillar below roof and rocker panel at base of door post and dog leg
•    Remove and install or replace

Rear Door

Cowl side trim

Center pillar trim

Sill plates

Seats

Quarter trim at sill

•    Loosen and pull back carpet and insulation as required
•    Remove and replace caulking for standard factory application

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish rocker and center pillar
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install or replace:

Front door

Rocker panel moulding

Control cables (latch release, etc.)

Restraint systems

Fluid lines

Headliner

•    Remove and replace or loosen rear edge of front fender
•    Trimming of welded assembly to be installed