Doors/Center Pillar & Rocker R&R

 

Included Operations

•    Remove and replace inner and outer rocker panels and center pillar
•    Cut center pillar below roof and rocker panel at base of door posts and dog leg
•    Remove and install or replace:

Front and rear doors

Cowl side trim

Center pillar trim

Quarter trim at sill

Door trim panels

Lock cylinder

Sill plates

Seats

Water/dust barrier

•    Loosen and pull back carpet and insulation as required
•    Remove and replace caulking for standard factory application

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish doors, center pillar and rocker panel
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install or replace:

Mouldings, nameplates, etc.

Control cables (latch release, etc.)

Restraint systems

Fluid lines

Outside mirror

Headliner

•    Replace or transfer parts attached to door (example: outside handle, glass, run channels, regulator, vent assembly, weatherstrip)
•    Remove and replace or loosen rear edge of front fender
•    Recode lock cylinder
•    Remove from salvaged assembly:

Interior trim panels

Lock cylinder

•    Trimming of welded assembly to be installed