Roof Section R&R

 

Included Operations

•    Cut in windshield and back glass openings
•    Remove and install or replace:

Windshield, seals or mouldings

Side and back glass, seals or mouldings

Headliner (All types)

Sunvisors or grip handles

Front and rear seats (Passenger/Pickup vehicles)

Front seats (Van/Utility vehicles)

Lift gate

Quarter trim

Weathercords

Windshield pillar trim

Center pillar trim

•    Remove and replace caulking for standard factory application

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish roof section
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install or replace:

Restraint systems

Luggage rack

Roof cap and/or vinyl cover

Adhesive exterior trim

Stripes, decals, transfers or overlays

Drip mouldings

Sound deadener

•    Trimming of welded assembly to be installed

                                      IMPORTANT REMINDER: No windshield, back or quarter glass (if applicable), or flush mounted reveal mouldings can be removed without the possibility of breakage. Unintentional damage to glass that is considered a structural member by the vehicle manufacturer may occur when attempting alignment pulls to correct unibody collision damage. Agree beforehand who will incur the charge for damage occurring during normal R&R or R&I, and whether additional labor time will be required to perform R&I operations on glass secured by urethane.