Rear Section & Roof R&R

 

Included Operations

•    Cut in windshield openings and front door openings
•    Remove and install or replace:

Quarter trim

Plastic wheelhouse liners

Windshield, seals or mouldings

Rear seat

Front seats

Center pillar trim

Sill plates

Bumper assembly

Luggage compartment trim

Lock cylinder

Lock strikers

Water/dust barriers

•    R&I carpet and insulation as required
•    Remove and replace caulking for standard factory application

                                      IMPORTANT REMINDER: No windshield, back or quarter glass (if applicable) or flush mounted reveal mouldings can be removed without the possibility of breakage. Agree beforehand who will incur the charge for damage occurring during normal R&R or R&I and whether additional labor time will be required to perform R&I operations on glass secured by urethane.

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish rear section
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install or replace:

Headliner (All types)

Restraint systems

Suspension assembly

Back glass, seals or mouldings

Antenna

Fuel tank

Mouldings, nameplates, etc.

Control cables (latch release, etc.)

Fluid lines

Front and rear doors

Exhaust system

Lamp assemblies

Center console

•    Recode lock cylinder
•    Remove from salvaged assembly:

Interior trim panels

Lock cylinder

•    Trimming of welded assembly to be installed