Quarter & Back Panel R&R

 

Included Operations

•    Cut in window openings at base or door post or dog legs, includes wheelhouse
•    Remove and install or replace:

Side and back glass, seals or mouldings

Quarter glass, seals or mouldings

Rear seat

Sill plates

Parcel shelf trim

Quarter trim

Plastic wheelhouse liner

Tail lamps

Bumper assembly

Luggage compartment trim

Lock cylinder

Lock strikers

Filler panel, stone deflector or rear lower valance

Water/dust barrier

•    Remove and replace caulking for standard factory application
•    Loosen or pull back cloth type headliner, carpet and insulation as required
•    Loosen convertible top

                                      IMPORTANT REMINDER: No back or quarter glass (non-movable) or flush mounted reveal mouldings can be removed without the possibility of breakage. Agree beforehand who will incur the charge for damage occurring during normal R&R or R&I and whether additional labor time will be required to perform R&I operations on glass secured by urethane.

                                      IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.

Not Included Operations

•    Refinish quarter and back panel
•    Remove and/or apply:

Anti-corrosion rust resistant materials

•    Remove and install or replace:

Headliner (All types)

Restraint systems

Suspension assembly

Antenna

Fuel tank

Control cables (latch release, etc.)

Fluid lines

Luggage lid

Liftgate

Wheel

•    Recode lock cylinder
•    Remove from salvaged assembly:

Interior trim panels

Lock cylinder

•    Remove and replace:

Floor pan

•    Trimming of welded assembly to be installed