Adjust Front Alignment |
|
|
Included Operations Position vehicle on alignment rack and check/adjust tire pressure Check ride height and adjust to vehicle manufacturer specifications Set-up gauges on all 4 wheels and check wheel run out and front suspension for wear Determine vehicle tracking by checking thrust angle to vehicle center line Center steering wheel Adjust front caster, camber and toe-in where applicable Perform vehicle manufacturer recommended shimming procedures if necessary Remove vehicle from alignment equipment Verify alignment by road test |
Not Included Operations Diagnostic road test to determine if alignment operations are necessary Straighten or replace suspension parts and/or structural components Shift or align engine subframe/crossmember and/or axle housing Remove and install steering wheel Non-vehicle manufacturer shimming Adjust wheel bearings Adjust rear wheel alignment Labor times for Wheel Alignment are based on the use of Four Wheel Alignment equipment to ensure that a minimum Thrust Angle Alignment is provided in all instances where a Four Wheel Alignment cannot be performed. If other than Four Wheel Alignment equipment is used, some adjustment in labor times may be appropriate. |
|
Mitchell Support: |
|