Rear Body Lower Panel R&R
Included Operations
|
•
|
Remove and Install: Rear bumper, Filler panel, applique/finish panel, stone deflector or lower valance |
|
•
|
Loosen and pull back: Weatherstrip attached to panel |
|
•
|
Remove and install or replace: Impact absorbers or mounting arms if necessary to perform operation, Lock cylinder attached to panel, Latch attached to panel, Lock striker attached to panel, Rear body interior trim |
|
•
|
Remove caulking/seam sealer for panel R&R. Replacement of caulking/seam sealer to obtain water sealing properties of the panel seams
|
|
•
|
Remove clip type moulding for base model vehicle |
Not Included Operations
|
•
|
Refinish rear body panel |
|
•
|
Remove and/or apply: Anti-corrosion rust resistant materials |
|
•
|
Remove and install fuel tank assembly |
|
•
|
Remove and install or replace: Quarter panel interior trim, Wiring and/or wiring harness |
|
•
|
Remove and install adhesive exterior trim; add to clean and retape |
|
•
|
Replace new adhesive exterior trim; deduct one-half of R&R time |
|
•
|
Apply caulking/seam sealer for additional sound deadening and/or to replicate original factory appearance, texture or color
|
|
•
|
Install stripes, decals, transfers or overlays |
|
•
|
Drill holes for installing exterior trim |
|
•
|
Cut holes for installing lamps |
IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.
IMPORTANT REMINDER: Labor times for inner panels, rails or reinforcements are with outer panels removed.