Side Body Panel R&R
Included Operations
|
•
|
Remove and install: Front door, Rear door, Front seat, Rear seat, Parcel shelf trim, Quarter trim, Plastic wheelhouse liner, Luggage compartment trim, Rear lamp assemblies, Rear bumper, Filler panel, stone deflector, or rear lower valance |
|
•
|
Remove and install or replace: Non urethane set glass (Windshield and moulding, Back window and moulding), Quarter window and moulding, Sun visor, if replaced at roof, Roof rail moulding, if replaced at roof, Cowl top panel, Cowl trim, Weathercords and weatherstrips, Pillar trim, Sill plates, Jamb switches, Lock striker, Bolt-on extension |
|
•
|
Remove and replace urethane set glass: Windshield and mouldings, Back window and moulding, Quarter window and moulding |
|
•
|
Loosen and pull back: Cloth type headliner as required, carpet and/or insulation as required |
|
•
|
Remove caulking/seam sealer for panel R&R. Replacement of caulking/seam sealer to obtain water sealing properties of the panel seams
|
|
•
|
Replace clip type moulding for base model vehicle |
Not Included Operations
|
•
|
Refinish side body panel |
|
•
|
Remove and/or apply: Anti-corrosion rust resistant materials |
|
•
|
Remove and install: Front fender, Preformed or molded type headliner, Fuel tank |
|
•
|
Remove undamaged urethane set glass: Windshield and moulding, Back window and moulding, Quarter window and moulding (See Example Below) |
|
•
|
Remove and install or replace: Instrument panel assembly, Door hinges, Air conditioning and heater parts that interfere, Wiring and/or wiring harness, Control cables (example: latch release), Fluid lines, Decals (example: EPA, body identification, caution/danger), Rocker moulding, Wheel, Antenna |
|
•
|
Remove and replace inner panels |
|
•
|
Replace sound deadening |
|
•
|
Remove and install adhesive exterior trim; add to clean and retape |
|
•
|
Replace new adhesive exterior trim; deduct one half of R&R time |
|
•
|
Install stripes, decals, transfers or overlays |
|
•
|
Apply caulking/seam sealer for additional sound deadening and/or to replicate original factory appearance, texture or color
|
|
•
|
Drill holes for installing trim |
|
•
|
Cut holes for installing lamps |
IMPORTANT REMINDER: Labor times for inner panels, rails or reinforcements are with outer panels removed. Also, no windshield, back or quarter glass (if applicable), or flush mounted reveal mouldings can be removed without the possibility of breakage.
Side Body Sectioning Explanation:{Italic}see
IMPORTANT REMINDER: When the quarter panel is sectioned from a Side Body Assembly the time is to cut in the Window Opening/Sail Panel area and the R&R of the quarter glass and/or back glass is included.
SPECIAL NOTE: Procedure Number 15 includes removal of damaged urethane set glass and replacement with new glass. The Procedure does not include allowances for necessary precautionary measures to remove undamaged urethane set glass, nor clean up of the old adhesive on the glass. If the existing urethane set glass is undamaged and will be reused, the labor time difference between the glass R&R and R&I represents the not included allowance.
Example: A Side Body Panel allowance includes a Back Glass R&R of 2.0 hr. The R&I of the back glass is 2.3 hr. The difference of .3 hr. between Back Glass R&R (2.0 hr.) and R&I (2.3 hr.) has not been factored into the Side Body Panel allowance.