Door Opening Panel R&R
Included Operations
|
•
|
Remove and install: Front door, Rear door, Front seat, Rear seat, Quarter trim |
|
•
|
Remove and install or replace: Sun visor, if replaced at roof, Roof rail moulding, if replaced at roof, Cowl top panel, Cowl trim, Weathercords and weatherstrips, Pillar trim, Sill plates, Jamb switches, Lock striker |
|
•
|
Remove and replace urethane set glass: Windshield and mouldings |
|
•
|
Loosen and pull back: Cloth type headliner as required, Carpet and/or insulation as required |
|
•
|
Remove and replace caulking for standard factory application |
Not Included Operations
|
•
|
Refinish door opening panel |
|
•
|
Remove and/or apply: Anti-corrosion rust resistant materials |
|
•
|
Remove and install: Front fender, Preformed or molded type headliner |
|
•
|
Remove undamaged urethane set glass: Windshield and moulding (See Example Below) |
|
•
|
Remove and install or replace: Instrument panel assembly, Door hinges, Air conditioning and heater parts that interfere, Wiring and/or wiring harness, Control cables (example: latch release), Fluid lines, Decals (example: EPA, body identification, caution/danger), Rocker moulding, Antenna |
|
•
|
Remove and replace inner panels |
|
•
|
Replace sound deadening |
|
•
|
Remove and install adhesive exterior trim: add to clean and retape |
|
•
|
Replace new adhesive exterior trim: deduct one half of R&R time |
|
•
|
Install stripes, decals, transfers or overlays |
|
•
|
Drill holes for installing exterior trim |
IMPORTANT REMINDER: Labor times for inner panels, rails or reinforcements are with outer panels removed. No windshield, back or quarter glass (if applicable), or flush mounted reveal mouldings can be removed without the possibility of breakage or damage that will require replacement. Unintentional damage to glass that is considered a structural member by the vehicle manufacturer may occur when attempting alignment pulls to correct unibody collision damage. Agree beforehand who will incur the charge for damage occurring during normal R&R or R&I operations.
IMPORTANT REMINDER: Sectioning of a panel may or may not be recommended by vehicle manufacturer. This procedure should only be performed when a qualified and knowledgeable technician has determined that the operation does not jeopardize the integrity of the vehicle.
SPECIAL NOTE: Procedure Number 15 includes removal of damaged urethane set glass and replacement with new glass. The Procedure does not include allowances for necessary precautionary measures to remove undamaged urethane set glass, nor clean up of the old adhesive on the glass. If the existing urethane set glass is undamaged and will be reused, the labor time difference between the glass R&R and R&I represents the not included allowance.
Example: A Door Opening Panel allowance includes a windshield R&R of 2.0 hr. The R&I of the windshield is 2.3 hr. The difference of .3 hr. between windshield R&R (2.0 hr.) and R&I (2.3 hr.) has not been factored into the Door Opening Panel allowance.